Bambu p1s
Pla. Its been dried in dehydrator for 4 hours at 55
Ironing is off (seemed to be the same with ironing on)
Ive tried turning the temp down to 210
There is a prime tower and purging is set to 1x
Flow rate is 0.96
Aux fan is off
Relatively new nozzle (less than a couple months old and I dont print that often)
I dont know what other info might be relevant
Its not the absolute top surface though, the black icons are raised higher and those look fine.
Really at a loss. Does anyone have any ideas?
Is part of the print lifting from the bed during print? That happens sometimes and it would make the nozzle dig into the already printed layers on that side