Hi all,

I’m doing an experiment with a cabinet for filament with a small dehumidifier in it. I can get it to sit at 35%, but not much lower. I’ve sealed the cabinet with foam tape, and dried most of the filament first.

Are there any tricks to help improve performance of the mini dehumidifier? Maybe adding more heat to the cabinet?

The goal would be to use Home Assistant and the humidity sensor to turn things on and off as needed.

Thanks!

  • Fmstrat@lemmy.worldOPEnglish
    1·
    1 hour ago

    While I’d rather have 2% accuracy than 5% on paper, it’s been fine, and checking with higher quality sensor has always put me within 1%.

    Also, I mentioned in another comment it was a peltier, and I’d love to do SS but just soooo expensive. :(