acargitz@lemmy.ca to 3DPrinting@lemmy.worldEnglish · 22 days agoAny ideas what I did wrong here? What caused these blobs?lemmy.caimagemessage-square7fedilinkarrow-up125arrow-down12
arrow-up123arrow-down1imageAny ideas what I did wrong here? What caused these blobs?lemmy.caacargitz@lemmy.ca to 3DPrinting@lemmy.worldEnglish · 22 days agomessage-square7fedilink
minus-squareacargitz@lemmy.caOPlinkfedilinkEnglisharrow-up3·22 days agoElegoo Centauri Carbon, and I’m using Orca on Linux.
minus-squareeinkorn@feddit.orglinkfedilinkEnglisharrow-up2·22 days agoHave you completed the calibration steps in Orca Slicer?
minus-squareacargitz@lemmy.caOPlinkfedilinkEnglisharrow-up2·22 days agoNope, didn’t know I had to, I’ve had multiple prints succeed previously, but also clogs often enough to be annoying, so maybe that’s it. Thank you very much for the pointer, let’s hope it’s what was missing.
Elegoo Centauri Carbon, and I’m using Orca on Linux.
Have you completed the calibration steps in Orca Slicer?
Nope, didn’t know I had to, I’ve had multiple prints succeed previously, but also clogs often enough to be annoying, so maybe that’s it. Thank you very much for the pointer, let’s hope it’s what was missing.