Mine looked like shit inside, and I bet yours do to.
I had some TPU85 tangled up in the gears, requiring a disassembly, so I figured I’d give it a proper clean while I already had it taken apart.
Mine looked like shit inside, and I bet yours do to.
I had some TPU85 tangled up in the gears, requiring a disassembly, so I figured I’d give it a proper clean while I already had it taken apart.
Is this sv08? I have it on my list of printers to buy (owned sv06 and ace before) is it any good? Any recurring problems?
Upd: read you comment in another thread about it
SV08 Max - the blob was my fault for not watching the first layer.
What’s that goop? Not sure if burnt filament from a leaky assembly, or epoxy from trying to seal said leak.
Burnt filament, actually came off easily.
That’s looks like you fucked up when you assembled the hotend and didn’t do it correctly.
Nah that’s just creality qc, it was preassembled.