Even with perfect measurements it’s impossible to get to that line straight unless the frame is perfectly square. This not only completely solves that issue but also saves a ton of time not having to measure and cut them one by one.

Also the lumber I picked turned out to be 10 cm longer than the deck and I even picked the exact right amount. By the time I was done I only had a basket of <10 cm off-cuts.

  • NigelFrobisher@aussie.zone
    link
    fedilink
    arrow-up
    3
    ·
    edit-2
    1 day ago

    Do you not need to treat the exposed ends several times then though? I gave up on a project like this because it just felt like it would rot again quickly.

      • Iconoclast@feddit.ukOP
        link
        fedilink
        arrow-up
        4
        arrow-down
        1
        ·
        21 hours ago

        The treatment generally goes into the wood only few centimeters so in some cases the cut ends do need to be treated. I’ve replaced pieces of deck framing in the past that had rotted out because this wasn’t taken into consideration.

      • NigelFrobisher@aussie.zone
        link
        fedilink
        arrow-up
        1
        ·
        23 hours ago

        I think that’s what the problem with the existing deck was lol. Also no-one uses hardwood cos it costs so much more.

        • HerbGrower@slrpnk.net
          link
          fedilink
          arrow-up
          1
          ·
          10 hours ago

          Even softwood seems so expensive. Plywood is probably the extent of my budget for a lot of things. Not sure how well it lasts outside or how treatable it is though so just haven’t really made much.

    • atomicbocks@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 day ago

      I am also curious about this, it looks like a place where water will collect in between. At least where I live, maybe this person lives in a dryer climate?

      • Iconoclast@feddit.ukOP
        link
        fedilink
        arrow-up
        3
        ·
        9 hours ago

        This is under a roof so it doesn’t get wet regularly. However even if it did that would be okay due to the NTR-AB grade treatment on the wood. It resists water for as long as it gets to dry out in between. For framing I use NTR-A grade which can withstand being constantly wet but there the cut ends needs to be treated or else that’s where the water gets in and it’ll rot from the inside out since pressure treatment is only on the surface.

      • bluGill@fedia.io
        link
        fedilink
        arrow-up
        1
        ·
        1 day ago

        I can’t say for sure from pictures but my guess is everything is safe for in water use and so no worry. It doesn’t take much to drain the water out